PDA

View Full Version : What size socket rench for bolts in HRAP2?

Shodokan123
03-19-2008, 10:34 PM
lmk

thx
EvilSamurai
03-19-2008, 10:59 PM
7mm nut screwdriver or you can be ghetto like me and use needle-nose pliers.
Shodokan123
03-20-2008, 12:06 AM
7mm nut screwdriver or you can be ghetto like me and use needle-nose pliers.

where would be the best place to buy one of those?
EvilSamurai
03-20-2008, 12:41 AM
where would be the best place to buy one of those?

Hardware store. I just used needle nose pliers i found in my garage.
BigEd80
03-20-2008, 07:17 PM
where would be the best place to buy one of those?

Try your local Sears, that's where I got mine.
Tetsuosan
03-20-2008, 08:08 PM
After modding the stick, when putting the bolt, locking washer, and nut do not tighten it with the driver. If you do you will make the hole wider. Tightening it by hand will more than suffice.
RockCho
03-22-2008, 03:37 PM
9/32 inch socket wrench.

Also, to add to what Tetsuosan said, you can just tighten it by hand for the most part, but you can tighten it with the wrench, just do it to the point where you can't turn it anymore without excess force. Turn the nut with a feathered twist until there's *any* resistence. This will keep it from getting loose on it's own and not be too tight to the point where you may damage the plastic shell.