SF Pad PCB question

[Canto]

I'm building a custom and want to use a SFII pad that I have. Its the 15th anniversery version.

Here are the pics:

http://i15.photobucket.com/albums/a362/mewimakitten/IMG_4060.jpg
http://i15.photobucket.com/albums/a362/mewimakitten/IMG_4061.jpg
http://i15.photobucket.com/albums/a362/mewimakitten/IMG_4063.jpg
http://i15.photobucket.com/albums/a362/mewimakitten/IMG_4062.jpg

2 Qs

1) All I have to do is drill tiny holes through the golden circles and shove a 22 AWG wire into it and solder it?

2) Since the directions have grounds.. do I get the JLF with the 5 pin connector? Or the one without the 5 pin? Since the pads directions has its own grounds?

I have wired a HFS3 PCB before and it had holes for the grounds but the 5 pin JLF still worked when I put the black ground into one ground hole.. will it work the same on this pad?

Thanks.

[zerolionheart51]

canto,

1. yea just drill tiny holes in the golden circle and solder it

2. the sf pad has a common ground, so just get the jfl with the 5 pin and solder it to any ground, or daisy chain it to the buttons

[Canto]

Alright, thats all I needed to know.

Thanks a lot man!

Thread can be closed/burned.

[KnightWarrior]

Is there a way builing a Better D-Pad on the Controller