How far down should quick disconnects go onto button prongs?

jujumburajujumbura Joined: Posts: 59
edited January 13 in Tech Talk
Hey all,

I'm working on my first mod of a fightstick, putting some Sanwas into my cheap Madcatz Alpha. Things are going pretty well, but one thing that surprised me is that my quick disconnects don't seem to go all the way down onto the button prongs. They cover that first round "hole", but not the longer "slot" below it. It seems like the disconnect should be long enough to cover the whole thing, but I can't seem to push it any farther, wiggling as much as I can.

Should I be trying to get the disconnect to totally cover that prong? I'm just a bit nervous about pushing on it as hard as I can 0_0 ..... I should note, that I have tested them and they do work when down only this far. I'm just worried that they won't fit in the case when it's closed.

Thanks for any advice!

Comments

  • jujumburajujumbura Joined: Posts: 59
    Here is a pic of the button with nothing on...

    https://i.imgur.com/BY2cc5N.jpg

    And here is pic of the button with the quick disconnects, as far as I can get them...

    https://i.imgur.com/ZiGFuSb.jpg

    Thoughts?
  • killkong1211killkong1211 Joined: Posts: 103
    They should go further, you need to give a little force, but if you don't feel comfortable with it or if you feel the amount of force you're exerting on them is too much, stop.
    As long as it works there's no issue though, if they come loose you may need to secure them a bit more.
  • kedawakedawa . Joined: Posts: 412 ✭✭✭✭✭ OG
    edited January 13
    Some quick disconnects require a lot of force to get fully seated. When I moved the buttons around in my Hori FE, I had to use needle nose pliers to push the connector onto the terminal, while holding the button down to keep the switch from popping out.
    The Sanwa buttons in my TE stick weren't quite that bad, but I was still afraid that I would break the terminal off sometimes.
  • jujumburajujumbura Joined: Posts: 59
    Thanks guys,

    So after reading your replies I took a deep breath and lay into that disconnect, with a finger pushing the button from the other side. They did indeed move down much farther ( most of the prong is covered now ) with a bit of a click.

    Man I had to work it though. And I was feeling a “pop” in my button too; it seems like the black box moves a bit. But it all seems to move back into place once I press the button normally?...

    Good to know others have had to push so hard as well.
  • killkong1211killkong1211 Joined: Posts: 103
    jujumbura wrote: »
    And I was feeling a “pop” in my button too; it seems like the black box moves a bit. But it all seems to move back into place once I press the button normally?...

    Yeah that's normal, its just some small plastic clips holding the switch in since they can be swapped/replaced easily.
    Fret not!
Sign In or Register to comment.