3 Holes on my Hrap won't screw in


#1

The screws just fall through and they don’t tighten so anyone have any idea how I fix this?


#2

The holes are stripped. I would say put some wood putty in the holes wait for it to dry and then screw your screws in.


#3

i used thicker screws and i only put them in the outer 4 corners


#4

Between the metal plate and each screw’s respective hole, put a strip of electrical tape, should tighten up the hole pretty well when the screw grabs the tape and takes it with it, and you won’t see it.


#5

Another thing you could do is just get some wider screws. Go to a hardware store, buy some screws that are a bit bigger around than the ones that fell through, and try those. Good luck!


#6

Great ideas, I have to remember them if ever I’m in this situation.