Absolute Question and Answer Thread v.3 (ASK YOUR QUESTIONS HERE!)


#4904

Did you solder at all? Maybe you made a solder bridge between Down and GND on the board. Also make sure your 5 pin harness is oriented correctly both on the board and the stick


#4905

No soldering was done. What makes me think it’s the PCB is that even when the 5pin is disconnected from the stick and the board, the down input still registers…


#4906

Was it like that even before you swapped out the stick and buttons?


#4907

For a TE2 (PS4/XBOne), I’m looking for a replacement connector cable from the main PCB to the LED board. Where can I find one?


#4908

Yeah, I was definitely getting input errors with the stock stick before the swap. I had hoped a new stick would have fixed it…


#4909

Your stick is probably defective then. You could return it or whatever or just switch out the PCB


#4910

I’d have to replace it since I voided the warranty. Are there any PCBs that will work with the existing parts or do I have to gut another alpha stick?


#4911

Any PS3+PS4 board will work but you may need to solder. Depends which PCB you use.


#4912

Where can i find the brooks board all soddered up so all i gotta do is screw it into my honey comb panel in my atrox?


#4913

Paradise arcade shop. You can choose all headers soldered, however keep in mind that some of the soldered headers will just be pins, and some will be in black connectors that will not be compatible with a JST connector found at the end of some cables, so you would have to crimp the connections yourself. The connectors that are just pins will be able to fit a JST cable with the right size. Example: The USB soldered header on the brook UFB fits the Qanba Q1/Q2/Q4raf USB cable perfectly (the shield ground wire and hole on the Q4 cable will not be connected to anything, though).


#4914

Can anyone tell where I can get some new art for my xboxone sick and how to install it . It’s my first time so go slow with me lol


#4915

Which Xbox stick?


#4916

@Darksakul Madkatz TE 2


#4917

http://www.madcatz.co.jp/files/Blank_faceplates_xbox_ps.zip

That’s the template for the TE2, download that, find the xbox layout, and create whatever artwork you want with it. Print it out on 11x14 paper and just cut off the unused parts and the holes for the buttons and stick. When you pop open the case there will be 8 screws to remove that secure the black frame to the case, once removed the black frame can be taken off and the new artwork placed underneath the thin plastic cover. There are plenty of videos you can check out on youtube if you need to see the actual process being performed.


#4918

thanx @Clandestine


#4919

Did anyone who plays SFV on PC ever get the ue4 kiwigame error and get a fix to it?


#4920

So whats the issue with xbox one sticks not working on pc. I know its a driver issue. But i remember mark man saying its because the te2 pcb and atrox pcb are different from how 360s functioned ans it would be ms to correct the issue i cant remember where i saw him discussing it


#4921

I plan on getting sfv for when I upgrade my PC and I play sfiv with my xbox360 stick already so it should work right??


#4922

360 sticks work fine on pc its xbox one sticks that dont


#4923

Anything specific I should pay attention to if I want LED lights from inside a stick to shine through the sides of the top plexiglas? I’d probably only need some holes if there’s an mdf plate between the plexiglas and the insides with wiring, right?

Shining through the sides like with this one: https://i.imgur.com/zU76FEf.jpg