Absolute Question and Answer Thread v.3 (ASK YOUR QUESTIONS HERE!)


No soldering was done. What makes me think it’s the PCB is that even when the 5pin is disconnected from the stick and the board, the down input still registers…


Was it like that even before you swapped out the stick and buttons?


For a TE2 (PS4/XBOne), I’m looking for a replacement connector cable from the main PCB to the LED board. Where can I find one?


Yeah, I was definitely getting input errors with the stock stick before the swap. I had hoped a new stick would have fixed it…


Your stick is probably defective then. You could return it or whatever or just switch out the PCB


I’d have to replace it since I voided the warranty. Are there any PCBs that will work with the existing parts or do I have to gut another alpha stick?


Any PS3+PS4 board will work but you may need to solder. Depends which PCB you use.


Where can i find the brooks board all soddered up so all i gotta do is screw it into my honey comb panel in my atrox?


Paradise arcade shop. You can choose all headers soldered, however keep in mind that some of the soldered headers will just be pins, and some will be in black connectors that will not be compatible with a JST connector found at the end of some cables, so you would have to crimp the connections yourself. The connectors that are just pins will be able to fit a JST cable with the right size. Example: The USB soldered header on the brook UFB fits the Qanba Q1/Q2/Q4raf USB cable perfectly (the shield ground wire and hole on the Q4 cable will not be connected to anything, though).


Can anyone tell where I can get some new art for my xboxone sick and how to install it . It’s my first time so go slow with me lol


Which Xbox stick?


@Darksakul Madkatz TE 2



That’s the template for the TE2, download that, find the xbox layout, and create whatever artwork you want with it. Print it out on 11x14 paper and just cut off the unused parts and the holes for the buttons and stick. When you pop open the case there will be 8 screws to remove that secure the black frame to the case, once removed the black frame can be taken off and the new artwork placed underneath the thin plastic cover. There are plenty of videos you can check out on youtube if you need to see the actual process being performed.


thanx @Clandestine


Did anyone who plays SFV on PC ever get the ue4 kiwigame error and get a fix to it?


So whats the issue with xbox one sticks not working on pc. I know its a driver issue. But i remember mark man saying its because the te2 pcb and atrox pcb are different from how 360s functioned ans it would be ms to correct the issue i cant remember where i saw him discussing it


I plan on getting sfv for when I upgrade my PC and I play sfiv with my xbox360 stick already so it should work right??


360 sticks work fine on pc its xbox one sticks that dont


Anything specific I should pay attention to if I want LED lights from inside a stick to shine through the sides of the top plexiglas? I’d probably only need some holes if there’s an mdf plate between the plexiglas and the insides with wiring, right?

Shining through the sides like with this one: https://i.imgur.com/zU76FEf.jpg


No, my XBONE controllers all worked fine. Its the PS4 versions that don’t have XINPUT drivers that don’t work properly with SFV.