HRAP3 pcb in custom case?


Is it possible to rip the hrap 3 pcb and put it into a custom built case?

if so, could u bring along the buttons panel with home l3,r3 ect.?


it is. i have an extra hrap3 pcb and it would be very easy to use in a new case. its already pre-wired with qd’s and also has a jlf harness. the button panel is physically attached to the pcb.


anyone here done this before? any pics maybe?


Using that pcb is another stick is very possible. Trying to use the whole panel including buttons, that’d be very very very difficult.

Although I may be biased, I see using a Cthulhu in the custom as much easier, and wont cost you tearing an HRAP3 case apart.