I have the stick and it came with a little cylinder that comes around the stick and then you put the ball on top… whenever i play it, it moves around is there a way to make it not move? or did i install it wrong?
I assume you’re talking about the shaft cover. Try tightening the ball top more by using a flat head screw driver to hold the bottom still.
thanx!! will it stop the shaft from moving if i tighten the ball a lot more?
Cut a thin piece of tape and apply it along the side of the shaft, then fit the shaft cover over it. I recommend electrical tape, and experiemtn with different widths to get a snug fit. Probably has to be no more than 3/8" of an inch wide, there’s not much room in between the saft and the cover.