Hey guys, I’m new here. Been lurking for a couple years, and I finally decided to sign up. I’ve had a MadCatz BrawlStick for a while now, but I’ve only recently decided to put custom artwork on it. I went to FedEx Office and got a lami-label made. It’s been working well, but just today I noticed that a good chunk of the glossy, film-like layer on the top is starting to peel off on a corner of the art, and it won’t stay down. I can tape it back, but the giant air bubble left by it can still be seen, and it’ll most likely come off again. I tried to put some tape under it, but that didn’t work either, and it ended up ripping a little bit of the art off (just one little patch, it’s barely noticeable and almost blends in with my art). Anything I can do to fix this? Should I just get another label made with higher-quality paper?