Need help with wiring diagram


#1

I have a ps3 chun li te- s stick that I am putting a akishop ps360 into and I’m having a hard time finding the wiring diagram for the two 6 ribbon cables that go from the terminal block… I’ve searched the forum and came up empty. I’m looking for the diagram for those two cables… any answers will be greatly appreciated thank you


#2

So are you going to cut the ribbons at the Turbo Panel side?
Then separate each wire from ribbon and screw into PS360+ Screw Terminals?

Look under the Turbo Panel where the ribbons are soldered.
They are labeled.

Since you have a TE “S” one, there is one small mod to do.
It is to make Select and Start work.
You connect the KGND to GND.


#3

Yea I ran into a problem because my buddy cut the ribbon at the turbo panel and I’m not sure which side of the terminal block goes to the turbo panel
With everything mounted which side of the turbo panel does the left ribbon the block sit


#4

Left is bottom.
Right is top.


#5

Thank u for the help.


#6

Ok after everything is hooked up the only buttons that are working are the start, select, home, and the joystick… I can’t figure out what’s going on with all the other ones… also do I need to run a wire from the contact point on turbo? Where does it hook into? Its a ps360+ and I don’t see a screw down for it.


#7

There is no Turbo for PS360+ exist.

How did you get Home Button to work on Turbo Panel?
To have the Home Button, you solder wire for Home Signal and Ground on Turbo Panel.

Your other Buttons are not working because you did not properly wire Ground for them.


#8

I have a wire soldered from home signal and fround from turbo panel… would it be easier to dasiy chain th ground on the button and bypass the terminal block? Are there any advantages to having the termanil block


#9

I have a wire soldered from home signal and fround from turbo panel… would it be easier to dasiy chain th ground on the button and bypass the terminal block? Are there any advantages to having the termanil block? With both ribbons connected both ends are the ground for the buttons right?


#10

I got the ps360+ hooked up and it works on my ps3 and 360 but now I’m trying to get the leds on the turbo panel to turn on the player 1-4 lights


#11

You’ll have to set the Jumper on PS360+ for LED.
You have to solder wires from the Turbo Panel to PS360+ side.

If you have the LED Harness for PS360+ included, you can use that.
Plug into PS360+ and solder other end to LED on Turbo Panel.


#12

One more problem… my home button works perfect on the ps3 but does not work on the 360… Anyone have any ideas on what I could troubleshoot to find the problem