[Newbie] Make QANBA Q2 360 Compatible


#1

How would I go about doing this? I just need to know a guide to do it and what I would need.

Thanks


#2

Can you solder and follow instructions? 360 pad dual mod.
Can you not solder and need very easy steps? PS360+ PCB replacement.


#3

I am not going to go into fine detail on this as you can simply youtube it. But you you will basically need to remove the PCB from for stick and get a different pcb. There are different options out there but I only like messing with the ps360+ It’s like $60 on focus attack. Then you basically just wire in all the buttons and and directions of the stick along with the grounds into the new PCB and you are good to go.

Try youtubeing ps360+ installation to get a beter idea of what you are going to do. It’s not hard, but I feel like explaining it all is a waste when it’s easily found on youtube.


#4

Thank you guys, like said I just needed to know what I should look for.

Thanks again! :slight_smile: