Plz Help!


I’m new to this site, after reading many posts about arcade sticks etc, I wanted to know if I could take apart my crappy joystick (it’s the Powerwave blazblue one you get with the game). I was very interested in building my own arcade stick from scratch, so my question is, can I use the PCB board from that joystick and add sanwa buttons and stick? Any help on this would be greatly appreciated, as I am totally newb to this!


Post in the tech thread


If the PCB works in your PS3, there’s no reason why you can’t use it and wire up new buttons to it.

If you don’t have the tools needed to solder, you may be better off getting a a pre-assembled solderless Cthulhu PCB instead. It’d be much easier to work with and you’d only be spending a little bit more than if you went out and bought soldering equipment.


Your AV is killing me bro:rofl: that is all…