Question for OBSF's on SE stick


#1

Anyone else have to shave down the buttons sides a tad bit to make it fit? because it won’t fit even if i jam and press down on the sides. Either i’m weaksauce or i suck.


#2

I will probably use sandpaper (around 100 grit) if i were in your position.

But i am no expert, they might be better solutions.


#3

I got them down without sanding, you have to use both of your thumbs and force it down, aim for the outer layer, not the center. It was a bitch, but I did it on two sticks now.


#4

No shaving is needed. I think you aren’t pushing the buttons down hard enough. Make sure to push on the outer layer like thund3rcat said, not the center because that may damage the button itself.