QuickDisconnect problem


#1

I was putting a stick together and i notice that the quickdisconnects didnt fit snug on the buttons (seimitsu screw ins) they keep sliding off with a slight tug and i was wondering how i can get them snug fit like on the TE sticks?


#2

.110" Quick Disconnect for Buttons, not .187" size.
But even with .110" (2.79mm), have to get with Tab Thickness of 0.020" (0.51mm).


#3

.110" Quick Disconnect for Buttons, not .187" size.
But even with .110" (2.79mm), have to get with Tab Thickness of 0.020" (0.51mm).


#4

Tab thickness is the issue especially because most disconnect packages don’t even specify which they are

I just used some needle nose pliers and pinched them in a little until they were snug