Razer Atrox dual modding problem


#1

Hello there,

thanks for your attention, and i hope this is the right section to write this post.

i’ve a problem here. I’m dual modding an Atrox Xbox One arcade stick from Razer with a Hori Mini 4 PCB.
I added a neutrik USB adapter to have one cable for each pcb.
Now, both pcbs are common ground, so i use the classic commond ground wiring to connect ground and signals.
But, when i connect the usb or the atrox cable, buttons work well but the stick is not working. every direction i push is wrong, only UP is right.
I tried EVERYTHING.
Could you help me to find the problem please?
Thanks,

Mast


#2
  1. Take clear pictures of your dual-mod. A picture says a thousand words.

  2. On which platform are Right/Left/Down wrong and Up is correct? Just the XBO? Just PS4? Both?

  3. Just to be sure: you connected grounds and signals between the two PCBs, did you connect Vcc as well?


#3

Thanks for your answer.

  1. now everything is unmounted and in confusion, it would not help to take pics! i got angry and i was trying everything not in a clean way, heheeh

  2. on both

  3. i’ve to connect Vcc from a pcb to the other?


#4

I think that if i have 2 separated cables, i’ve not to connect vcc between pcbs, i’m wrong?


#5

Yup, your thought process is incorrect.

Golden rule of dual-modding: GND between all PCBs need to be connected, Vcc between all PCBs need to be connected, regardless of how you do the system-cables.


#6

Ok, i’ll connect the Vcc and i give you feedback. Thanks man!


#7

Ok, i found another problem, it was on a solder, damn.
But now, if i connect the Vcc on both pcbs, if i put PS4 cable in, it works, but if i put the Xbox One it doesn’t. and if i remove the vcc, both work.
I don’t know what to say… :\


#8

Post a pic


#9

Tomorrow i will, thanks.