Securing sanwa OBSC buttons


#1

I have a foehammer case. This is my first build. Unfortunately I bought the OBSC sanwas instead of the OBSN which would have been a lot easier. Is there any way I can secure the OBSC better so I don’t compromise the option of taking them off later. Any help would be appreciated.


#2

Not sure how you’d comprimise your ability to remove the buttons but if you’re worried about them moving around on you then a small (emphasis on ‘small’) amount of hot glue can help secure snap-in buttons that have been installed into panels that are too thick for the tabs to grip into.