Stick art Formatting Request


#1

Hello, would someone be so kind as to make this image conform properly to a STock SF AE Joystick Box.(so that the main focus of image is between buttons/sticks nicely)… maybe also stamp out that txt on the bottom right.

also, can someone give me advice on what kind of paper to print this on? Ima probably bring it to a kinknos or w/e printing place nearby that I can find. thanks


#2

theres noone that can help me?


#3

Dimensions?


#4

Total Dimension: 15 3/4" x 10 1/4"

buttons are a 5.5" x 2.5" block [of 8 buttons] with its center located 5 1/4" from the right side, and 3 3/4" from the top side

stick shaft is 1 3/4 radius, located 4 3/8" from the left side, and 4" from the top.

select button is 1/4" radius, located 3 7/8" from the left, and 1 3/4" from the top.

I can do a mcpaint bitmap for clarification


#5

Found a pic online and just overlayed it [though it was at an angle so some shit guess-timation was done]. Here’s what I’m guessing it would look like if placed on the stick. If you dig it, I can send you the image without the holes on it.


#6

looks good. could you reduce the image by like, ~80-85% ish to get his face above the buttons?

format & send plz. gbursine@gmail.com if its easier than hosting it on a 3rd party site. I am most grateful.


#7

I think this one came out pretty well. If you dig, I can send you the blank.


#8

ya, I think that placement works best, & is blank worthy.


#9

Here you go.