Tore Wire in TE


#1

I recently received a TE (at a very low price) where the metal slot that connects wires and the buttons has been tore. So essentially the metal part and the wire are disconnected. The current solution I have for this is to just swap my button layout and wiring where that button is not needed. I was wondering if it is possible to fix this problem tho and have all buttons functioning.


#2

Sure it’s a simple soldering job.
The diagram is around if you go looking


#3

You only need a crimper tool and a .110 quick disconnect to repair.

http://www.lizardlick.com/LL-Quick-Connect-110-Insulated_p_184.html


#4

Awesome!!

Thank you so much guys :smiley:


#5

the wire just needs to make contact with the prong on the button. you could technically just strip the wire and loop it around the prong, but it is a ghetto solution at best : ]