Wiring confirmation needed please


#1

Can someone confirm these are correct? Putting a JLF in my DC stick.

Thanks :slight_smile:

DC PCB

Ground - black
Up - brown
Right - red
Down - orange
Left - yellow

JLF

Ground - black
Up - orange
Right - green
Down - red
Left - yellow

Got them from googling, wired it up, but it’s not working :frowning:

EDIT _ It depends on orientation doesn’t it?


#2

Orientation does matter, but just look at the trace side of the PCB and follow the wires to each microswitch.


#3

From Toodles instructable on piggybacking an agetec to a UPCB:

*Left connector on the bottom is the stick connector. From left (black) to right (yellow), the wires are:

  1. Ground
  2. Up (brown)
  3. Right (red)
  4. Down (orange)
  5. Left (yellow)

The right connector on the bottom is the stick connector. From left (white) to right (red), the wires are:

  1. DC_2 (white)
  2. Sense (green)
  3. Ground (black)
  4. VCC (blue)
  5. DC_1 (red)*

Black is always going to be ground on your JLF, so once you have that connected just mess with the others until you’ve got it right.


#4

For the Dream Cast PCB:
LEFT = Yellow
DOWN = Orange
RIGHT = Red
UP = Brown
GROUND = Black

For Sanwa JLF-H, it depends on how the JLF is oriented.

So put how you want the Joystick to be, and just wire up to respective Dream Cast wires.


#5

What Dreamcast stick are you using? Agetec?


#6

Cheers gents, all done thanks to the diagrams, works a treat :slight_smile: