XBOX 360 wireless CG pad - 10k resistor trigger delete problem


#1

So I striped my controller down, and got the buttons and d-pad wired up, but in 3S:OE my short button refuses to work (only in a match). I figure I should add those 10k resistors to where my triggers were, but one of them just won’t solder.

I think I ripped off the small bit of metal that was on the board de-soldering the trigger (improperly). Now what? Is there any where else I can tap into? :frowning:


#2

Follow the trace, see if you can solder else where, or worst case scenario, clean a section of trace and solder to that.